Connecting AC Power (ICC-800)

NOTE: It is recommended that a licensed electrician perform the following power installation.

1. Remove the cover from the junction box.
2. Strip 1/2" off of each wire.
3. For all connections, route the wires through the conduit opening inside the junction box
4. For 120 volt connections twist the wires together using wire nuts as shown in Figure 1. For 230 volt connections twist the wires together using wire nuts as shown in Figure 2.
5. Cap any unused wires. Replace faceplate of junction box and screw into place.

NOTE: Wiring instructions for the ICC-800 SAT are included in the controller installation instructions supplied with the controller.