Programmable Delay Between Stations

This feature allows the user to insert a delay between when one station turns off and the next station turns on. This is very helpful on systems with slow closing valves or on pump systems that are operating near maximum flow or have slow well recovery.

1. Start with the dial in the RUN position.
2. Press and hold the button down while turning the dial to the SET STATION RUN TIMES position.
3. Release the button. At this point the display will show a delay time for all stations in seconds, which will be blinking. The DELAY icon shall also be lit at this time.
4. The display will show “SEC”. Use the and buttons to increase or decrease the delay time between 0 and 10 minutes in 1 second increments.
5. Pressing either the button or the button will allow for programming a longer delay between stations. The display will show the delay in minutes.
6. Press the and buttons to increase or decrease the delay time from 0 to 10 hours in 5 minute increments. To remove a delay between stations, press the button to change the delay time to SEC 0:00. The delay will no longer be active.
7. Return the dial to the RUN position.

NOTE: The Master Valve/Pump Start circuit will operate during the first 20 seconds of any programmed delay to aid in the closing of the valve and to avoid unnecessary cycling of the pump. It is recommended that a pressure relief valve be installed on the system should this 20 second delay be too long for a particular system. Consult your pump contractor or supplier for details.