Changing the Transmitter Address

Both the ICR Transmitter and Receiver have an “address” that they use when communicating. If the addresses do not match, the Receiver will ignore the transmission. Your ICR comes from the factory with both the transmitter and Receiver address set to 0. You may change the address to any value from 0-127 for added security. Note that if you change the Transmitter address, the Receiver must “learn” the new address as described in the “Preparing the Receiver for Use” section.

To change the Transmitter address:

1. If the unit is OFF (no display), power the Transmitter up by pressing any of the buttons for at least 1 second then releasing the button. The Transmitter will illuminate the active station.
2. Press the Mode button until the word “Address” appears on the display. The address will be blinking at this point. If more than 5 seconds go by without a button being pressed, the Transmitter will revert back to displaying the active station.
3. Use the or button to change the address to any value between 0 and 127. Then do not touch any of the buttons for 5 seconds and the display will stop blinking and return back to the active station.