Activating a Station with the ICR

The ICR system will allow you to remotely turn on and off any station on your Hunter controller with the press of a button. Once on, the station will run for the run time you have designated in the ICR transmitter.

To remotely activate a station or program:

  1. Plug your Receiver into an active SmartPort® wiring harness (one attached to a powered controller) and wait for 2 beeps indicating the Receiver is ready.
  2. If your Transmitter is not on (no display), press any button for at least 1 second and release. The Transmitter will display the active station.
  3. Use the or buttons to display the station or program (A, B, C, and D) you would like to start.
  4. Momentarily press the “ON” button to start the station or program. The Transmitter will display the word “TRANSMIT” and will flash for about 4 seconds indicating that it is sending the command to the Receiver. If you are near the Receiver, you will hear it beep 2 times, indicating that it has received the command.
  5. Press the “OFF” button at any time to turn off the station or program. The display will again read “TRANSMIT” and flash, and the Receiver will again beep twice. The ICR is designed to turn one station on at a time. Therefore, turning a station on while another is already on will cause the first station to turn off.
  6. If one of the programs (A,B,C, or D) is selected, all stations in the selected program will run sequentially for the run time programmed in the controller.

NOTE: The ICR remote can activate any station on the controller whether the controller dial is in the “System Off”, “Run” or “Run/Bypass Sensor” modes. If a sensor device has been wired to the controller, the ICR will not override the sensor for manual operation.