Mounting the Indoor Controller to a Wall

All necessary hardware is included for most installations.

NOTE: The indoor Pro-C is not weather or water resistant, and must be installed indoors or in a protected area. This device is not intended for use by young children. Never let children play with this device.

1. Select a location as close as possible to a standard electrical outlet that is not controlled by a light switch. The location should be protected from moisture and direct sunlight.
2. Remove the front panel from the Pro-C by pulling down the hinge release. Removing the front panel will ease installation of the controller.
3. Place the controller at eye level. Use the hole at the top of the controller as a reference and secure one 25mm screw (A) into the wall. Note: Install screw anchors if attaching to drywall or masonry wall.
4. Align controller with the screw and slide the keyhole (B) on top of the controller over the screw.
5. Secure controller in place by installing screws in the holes (C).

NOTE: Do not plug transformer into power source until the controller is mounted and all valves have been connected.