Mounting the Outdoor Controller to Wall

Pro-C Outdoor Mounting InstructionsNOTE: Outdoor model is water and weather resistant. Connecting the outdoor Pro-C to the primary power should be done by a licensed electrician following all local codes. Improper installation could result in shock or fire hazard. This device is not intended for use by young children. Never let children play with this device.

  1. Select a location that is conveniently close to a power supply.
  2. Make sure to abide by all electrical and installation codes when attaching to an external wall.
  3. Remove the front panel from the Pro-C by pulling down the hinge release. Removing the front panel will ease installation of the controller.
  4. Place the controller at eye level and align keyhole (A) on top of the controller and mark the spot as well as the three holes (B) on the bottom of the unit.
  5. Drill a 6 mm hole at each mark.
  6. Install screw anchors (C) into holes if attaching controller to drywall, masonry, or plaster walls.
  7. Holding the controller cabinet, line up the holes in the cabinet with the wall anchors or pilot holes.
  8. Drive a screw through each hole and secure but do not over tighten.

For PC-301-A: If the supply cord is damaged, it must be replaced by the manufacturer or service agent or a similarly qualified person in order to avoid hazard.