Programming the Controller (Continued)

Manually Run All Stations

  1. Turn dial to MANUAL-ALL STATIONS.
  2. You can select program A, B, or C by pressing the button.
  3. Press the button until desired starting station is displayed.
  4. Station run time will flash in the display. Use the or buttons to select the amount of run time for the station to water.
  5. Use the button to move to the next station.
  6. Repeat steps 3 and 4 to customize each station.
  7. Press the button until you reach the station that you would like watering to begin.
  8. Return dial to RUN (custom program will water, then controller will return to automatic mode with no change in the previously set program).

NOTE: The station that is on the display when you turn the dial to RUN will be the first station to run. The controller will then proceed to water in sequential order only. It will not water previous stations. Example: If you turn the dial to RUN with the display reading station 3. The controller will water stations 3 to 9 in the program, but not return to stations 1 and 2.

One Touch Manual Start and Advance

You can also activate all stations to water without using the dial.

  1. Hold down the button for 2 seconds.
  2. This feature automatically defaults to program A. You can select program B or C by pressing the program.
  3. The station number will be flashing. Press the button to scroll through the stations and use the or buttons to adjust the station run times. (If no buttons are pressed during step 2 or 3, the controller will automatically begin program A.)
  4. Press the button to scroll to the station you wish to begin with. After a 2 second pause, the program will begin.

This feature is great for a quick cycle when extra watering is needed or if you would like to scroll through the stations to inspect your system.

Clearing the Controller's Memory/Resetting the Controller

If you feel you have misprogrammed the controller, there is a process that will reset the memory to factory defaults and erase all programs and data that has been entered into the controller.

  1. Remove all power (unplug transformer and remove battery) and wait at least 1 minute.
  2. Press and hold down the , and buttons.
  3. Restore power to the controller.
  4. Release the , and buttons.