SRR Components

This section will give you a brief description of the components of the SRR. Each item will be discussed in further detail later, however this section can be helpful in getting acquainted with the Transmitter, Receiver, and SmartPort®.

TRANSMITTER

A. LCD Display

1. Run Time – Indicates the Station Run Time is being set when flashing.
2. Transmit – Indicates that the Transmitter is transmitting the programmed data to the receiver.
3. Main Display – Indicates various times and values.
   Number – Indicates either Station Run Time (1 to 30) or Station number (1 to 48).
   On – Indicates Transmitter is turning on a particular station.
   Off – Indicates Transmitter is turning off a particular station.
   Program (A, B, C) – Indicates program selected.
4. Address – Indicates that a new address for transmitting between the Transmitter and the Receiver is being set.

B. Control Buttons

5. – Increases the selected flashing display.
6. – Decreases the selected flashing display.
7. – Selects the selected flashing display.
8. – Cancels the selected flashing display.

C. Other

9. Battery Cover – Covers compartment for 9-volt alkaline battery.

RECEIVER

10. Control Button – Hold button down when plugging Receiver into SmartPort when programming a new address.
11. SmartPort Outlet (Male) – Outlet on back of Receiver that plugs into the SmartPort harness.
12. Antenna – Receives signals from Transmitter from up to 450’.

SmartPort®

13. SmartPort Outlet (Female) – Outlet on front of SmartPort that plugs into the SRR Receiver or other Hunter product.
14. Rubber Cover – Protects SmartPort from dirt and weather.
15. Control Wires – Red, white, and blue wires that connect to the terminal strip area of the controller.