Installing the SRR Remote Wiring Harness

NOTE: Any extension of the wires provided with the standard wiring harness may result in an error message on the controller display and possible malfunction of the remote due to radio interference. In some situations, lengthening of the standard harness may work fine, in others it may not work at all (it is site specific). In either case, it is recommended that installations where the SmartPort outlet will be located more than 5 feet from the controller that the installation be done using the shielded cable wiring harness (SRR-SCWH) to minimize the possible effects of electrical noise.

  1. Install a 1/2" female threaded “Tee” in the field wiring conduit approximately 12" from the SRC, ICC, or other Hunter controller.

NOTE: While the SmartPort has a protective cover to allow for outdoor installation, the SRR Receiver should only be used on a temporary basis, as the Receiver is not designated for permanent outdoor mounting.

  1. Feed the red, white, and blue wires of the SmartPort through the base of the “Tee” and into the controller wiring compartment as shown in Figure 1.
  2. Screw the SmartPort housing into the “Tee” (or other fitting) as shown in Figure 1.
  3. Route wiring harness into controller housing. Attach the red wire to the first AC screw slot. Attach the white wire to the other AC screw slot, and attach the blue wire to the R (or REM on some controllers) as shown in Figure 2.
  4. The wiring harness’ 1/2" male thread has a 90° ratcheting mechanism to allow the receiver to be set in a vertical position for the best reception.
Figure 1
Figure 2