Changing the Maximum Station Number

Your SRR Transmitter comes from the factory with the maximum station number set to 9. This means that when you use the and buttons to change the station, you may change it to any number between 1 and 9. However if you only have a 6-station controller, you will never need to access stations 7 through 9. Likewise, perhaps you will own a Hunter controller like the ICC which can have up to 48 stations. In this case you would want to access the stations above 9.

The SRR Transmitter allows you to set the maximum station number as follows:

  1. If the unit is off (no display), power the Transmitter up by pressing any of the buttons for at least 1 second then releasing the button. The Transmitter will first illuminate the entire display for 1 second then display the active station.
  2. Press the and buttons simultaneously, until the word “RUN TIME” along with the current Run Time is displayed. The display will be blinking at this point.
  3. While the display is blinking and showing the current address, press the button. The display will continue to blink, but the word “ADDRESS” will be illuminated.
  4. Press the button again. The display will continue to blink, but the word “ADDRESS” will no longer be illuminated.
  5. Use the and buttons to change the maximum station number to the value you desire. Then, do not press any buttons for 5 seconds and the display will stop blinking and return to the active station number
  6. You may now change the active setting to any station in the new station range.

Note: Black buttons indicate what is to be pushed.