Activating a Station with The SRR Remote Control System

The SRR System will allow you to remotely turn on and off any station on your SRC, Pro-C, ICC, or future Hunter controller with the press of a button. Once on, the station will run for the run time you have designated in the remote. To remotely activate a station or program follow the steps below:

1. Plug the Receiver into a SmartPort® that is connected to a powered controller and wait for two beeps indicating that the Receiver is ready.
2. If your Transmitter is not on (no display), press any button for at least one second and release. The Transmitter will first illuminate the entire display, then display the active station.
3. Use the and buttons to display the station or program you would like to start.
4. Press the button to start the station or program. The Transmitter will display the word “TRANSMIT” and the letters “On”. Both will flash for about 4 seconds indicating that it is sending the command to the receiver. If you are near the Receiver, you will here it beep 2 times. This indicates that the Receiver has received the command.
5. Press the button to turn off any station that is on. The display will read “TRANSMIT” and the letters “Of”. Both will flash for about 4 seconds, and the Receiver will beep again twice. The SRR System is designed to turn on one station at a time (unless you activate a program). Therefore, turning a station on while another station is operating will cause the operating station to turn off.

NOTE: The SRR remote can activate any station on the controller whether the controller dial is in the “SYSTEM OFF”, “RUN” or “RUN/BYPASS SENSOR” modes. If a sensor device has been wired to the controller, the SRR remote will NOT override the sensor for manual operation.