Addressing the WVC with the WVP

(WVP required to perform this function)

Each WVC controller requires a unique identification number for proper radio operation with the WVP. Setting unique addresses for each WVC allows for separate radio programming and manual operations with individual WVC controllers even though other controllers may be in the surrounding area. The unique address is a 3-digit number from 000 to 999. Once the address is set, you must remember the ID for future operation. (Refer to the WVP Owner’s Manual for detailed programming instructions).

To Set the Unique Address on the WVC:

1. Press the Transmit/Receive button on the WVP to enter the communications mode.(Lower portion of display).
2. Use the and buttons to change the 3-digit identification number. Use the button to make sure that the WVP is in the transmit mode with the arrow on the display pointing towards the address icon (see figure 1).
3. Unscrew the rear half of the WVC body to gain access to the battery compartment.
4. Install a standard 9-volt alkaline battery into the battery holder (see Connecting the Battery).
5. Wait for the red light inside the battery compartment to come on, this may take 10-15 seconds.
6. Immediately press and hold the Transmit/Receive button on the WVP. The WVP will beep twice when transmission commences. Release the button.
7. The WVP will beep twice again when the identification number has been learned by the WVC.
8. If the WVP illuminates the failed to communicate icon then start over from step 4.

NOTE: If no WVP communication takes place after the red light on the WVC comes on, the WVC will turn this light back off (after 20 seconds) and revert back to the address already programmed into the WVC.