Installing the Flow-Clik Sensor into the Sensor Body

The Flow-Clik Sensor Body comes with a plug that allows for installation of the Sensor Body into the irrigation system prior to installing the Sensor. This allows the sensor body to be installed separate of the sensor and prevents damage to the sensor during installation of the body.

NOTE: Do not attempt to remove the sensor plug or sensor while the system is under pressure.

To Install the Sensor Into the Body:

1. Turn the system pressure off.

2. Unscrew the cap from the top of the body (figure 1).

Figure 1: Unscrew the Cap from the Top of the Body

3. Use pliers or a screwdriver and carefully pry the plug from the body.

4. Insert the sensor into the sensor body (Check to make sure the two o-rings provided with the sensor are installed in the grooves at the lower end of the sensor). The sensor has a flat side that engages with a flat on the inside of the sensor body (figure 2).

Figure 2: Insert the Sensor into the Sensor Body

5. Replace the cap on the sensor body (hand tighten only).

6. Feed the two sensor wires through the hole in the cover and snap the cover on the cap.