Hunter Technical Support Document

Share

Clearing an Eco-Logic Controllers Memory

Topics: 
Adjustment, FAQs, Troubleshooting

If you feel that you have misprogrammed your controller, there is a process that will reset the memory to the factory defaults and erase all programs and data that have been entered into the controller.

1. Press and hold the , , and buttons while the controller is it's idle state as shown here.
2. While continuing to hold the three buttons from the previous step, press and release the Reset(RST) button in the lower wiring compartment with a paper clip or small screw driver.
3. Wait 2 seconds and release the , , and  buttons. The display should now show 12:00am. All programmed data has been cleared from the controller's memory and the controller can now be reprogrammed.

 

 

 

Resources

Rate this Article: 
No votes yet

Related Links