After all programming has been completed, press the 
Mode button until the time of day is displayed. This will enable automatic execution of all selected watering programs and start times.
Manual Run – All Stations 
Manual All Stations allows the operation of valves assigned to a program in sequential order.
Press and hold the 
button for three seconds. The 
will be displayed, along with the program letter. A station number will also be displayed.
Select program by pressing the 
button.
Use the 
or 
buttons to select the amount of time for the station to water if different from the run time displayed.
Use the 
button to move to the next station.
Repeat steps 3 and 4 until you reach the station at which you want watering to begin.
After 2 seconds of inactivity, manual watering will begin and sequence through each valve of the entire program. Once manual watering has been completed, the controller will automatically return to the automatic mode with no change in the previously set program.
Manual Run – Single Station 
Manual Single Station function allows the for operation of a single valve.
To run the controller in a single station mode follow steps below:
Step 1
Hold down the button until the screen changes.
Step 2
Press the button 3 times until you will see a hand with a number 1 in the middle.
Step 3
Now you are in manual single station mode.
Step 4
Using the button – go to the station desired.
Step 5
Add minutes desired by using the button.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.