Hunter Technical Support Document
How do I address the Wireless Solar Sync sensor to the Solar Sync receiver?
The Wireless Solar Sync Receiver and Sensor (transmitter) are already paired with the same address for an easy installation. When installed, the wireless Receiver will automatically go into a "search" mode looking for the signal from it's paired sensor. However, it is a good idea to initialize communication manually between the wireless Receiver and Sensor during installation to verify correct signal transmission.
To initialize communication manually between wireless Receiver and Sensor:
• After Receiver’s green and black wires have been connected, restore power to the controller.
• The red LED in the center of the wireless Receiver will turn on and stay solid for 10 seconds, indicating that it is in search mode, searching for a signal from a wireless sensor.
• While the red LED is solid and the wireless Receiver is in search mode, press and hold the spindle on the wireless Sensor. The LED on the wireless Receiver will blink 4 times and then turn off, indicating that the signal from the wireless Sensor has been acknowledged.
To Validate Receiver/Sensor Communication or Re-address:
• Press and hold the spindle on the wireless Sensor.
• The LED on the wireless Receiver will blink 2 times, confirming that the Receiver is addressed to the Sensor properly.
Note: In the event of a power outage (or any other reason when the Receiver loses radio contact with the wireless Sensor) the receiver will automatically go into search mode to re-establish communication with the Sensor once power is restored. However, when power is restored the controller will automatically go into rain shut off mode until communication with the Sensor is re-established, which may be up to 60 minutes (maximum). Performing the steps listed above to validate Receiver/Sensor communication will remove the controller from rain shut off mode and will return to its programmed irrigation schedule.