Hunter Technical Support Document
Rotor Nozzle Installation Procedure
|STEP ONE||STEP TWO|
Insert the plastic end of the Hunter adjustment wrench into the lifting socket of the rotor and turn 90 degrees. Pulling up the riser will allow access to the nozzle port for installation.
Nozzle insertion collar shown above, P/N 123200.
Visually check to make sure the nozzle screw is not blocking the socket where you are about to install the nozzle. Slip the nozzle into the nozzle socket, the nozzle socket is angled up 25 degrees.
The triangle on the rubber cover will always indicate the location of the nozzle and direction of the water's flow, when the rotor is retracted. After the nozzle is installed, turn the adjustment screw a quarter turn clockwise to hold the nozzle into place. Anymore than a quarter rotation of the radius reduction screw will result in a minimized radius.
Still not finding the answers?
Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage. Simply click on the contact button below to submit an email request.