| STEP ONE | STEP TWO |
|---|---|
I-40 Rotor and Turf Cup Kit |
Access the top cover screws by prying out the little covers one at a time. Be careful not to lose them. |
| STEP THREE | STEP FOUR |
Remove plastic screw covers |
After the screws are exposed you can use a common phillips head screwdriver to remove. |
| STEP FIVE | STEP SIX |
Remove both screws. |
Once the screws are removed you can now take off the stock body cap. |
| STEP SEVEN | STEP EIGHT |
If done properly the riser seal and riser seat should still be in place. |
You can now push on the turf cup body cap, while it's compressed tighten the screws. |
| STEP NINE | STEP TEN |
Hold cap whille tightening screws. |
Tighten both screws |
| STEP ELEVEN | |
With both screws tight it's now safe to install your sod into the turf cup. |
Resources
Still not finding the answers?
View more support documents [24]
Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage, simply click on the contact button below to submit an email request.
[25]