I-20 6" with Swing Joint
I-20 12 with Hunter Swing Joint
I-20 12 with Swing Joint
Replacing the Riser Seal on a Hunter rotor
|I-20 with Poly Pipe||STEP TWO|
Place the base of the riser on a solid surface and grip the spring and riser body firmly. With the other hand, snap off the body cap—with your palm on top of the logo cap, pull up with your fingers.
|STEP THREE||STEP FOUR|
While still gripping the spring and body, remove the rubber seal.
When you remove the seal, the spring's tension will be released. Remove the plastic spring and plastic springseat (if it was not pushed off by the spring).
Now that the old seal is removed, the new seals and plastic spring seat can slide over the top of the rotor's turret and onto the riser. Be sure to install the spring seat prior to the riser seal. After the new components are installed you can then reinstall the rotors body cap.
Still not finding the answers?
Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage. Simply click on the contact button below to submit an email request.