| FAQs, Installation Procedures, Troubleshooting | Why does my rain sensor not interupt the irrigation cycle? There are three possible reasons:The most common reason for non-activation on a Hunter rain sensor is the sensor itself has not encountered enough rain fall. Go out to the rai... >> Read More | |
| FAQs, Troubleshooting | Why is the rain sensor not turning off the sprinklers? There may be three possible reasons:The most common reason is because the sensor has NOT received enough rain to activate. Go out to the rain sensor and manually activate the ... >> Read More | |
| Adjustment, FAQs, Installation Procedures | How do I address the Wireless Solar Sync sensor to the Solar Sync receiver? The Wireless Solar Sync Receiver and Sensor (transmitter) are already paired with the same address for an easy installation. When installed, the wireless Receiver will automat... >> Read More | |
| FAQs, Troubleshooting, Video | Why is my Seasonal Adjustment so high or low, with a Solar Sync installed? Increasing the Water Adjustment option on the Solar Sync module will allow you to fine tune your station Run Times to either allow for more watering or less watering.For less ... >> Read More | |
| Adjustment, FAQs, Installation Procedures | How do I eliminate the ERR message on my Solar Sync? Controller shows ERR:Module wires not properly connected to controller terminals.Wires from the Solar Sync module to the controller have been severed.Solar Sync module shows E... >> Read More | |
| FAQs | What amount of rain is needed to shut off my system? The Rain-Clik, Wireless Rain-Clik, and Solar Sync provide instant shut off, thanks to Hunter’s Quick Response feature.The Mini-Clik is an adjustable model which can be set to ... >> Read More | |
| FAQs, Troubleshooting, Video | All my stations are too wet or too dry, what should I adjust? Use the water and feature on the Solar Sync module to adjust the percentages applied to the controller. It comes from the factory at 5, it adjusts 1-10 with 10 giving yo... >> Read More | |
| Adjustment, FAQs, Video | I have a station that is too wet or too dry, what should I adjust?
One station:
At any time you can simply increase or decrease Run Time to any individual station in the host controller and that station will adjust up and down with all the r... >> Read More | |
| Troubleshooting | Why is my Hunter Freeze sensor not disabling watering during freeze events? Check that the jumper tab was removed from across the two SEN terminals and also check that the sensor bypass switch on the controller is not in the Bypass position. It needs ... >> Read More | |
| Troubleshooting | How long does it take for a Hunter rain sensor to dry out? The dry out time could be as little as 4 hours depending on the weather conditions (temperature and humidity) and the rain threshold that is set. If the weather conditions rem... >> Read More | |
