Hunter Technical Support Document
How do I adjust my Hunter MP Rotator's radius and arc?
Arc Adjustment
|
|
Radius Adjustment Factory setting is for full radius, and the radius can be reduced by 25%. With the MP Rotator tool or a small flat bladed screwdriver, rotate the Radius Adjustment Screw: -Clockwise (4 full turns) to decrease the radius -Counter-clockwise (4 full turns) to increase the radius
Note: Radius reduction is intentionally limited by a slip clutch mechanism to ensure reliable rotation. To prevent damage during adjustment, the MP Rotator does not completely shut off like a spray nozzle. To achieve maximum radius reduction with any MP Rotator model use a 30 PSI (2 BAR) regulating spray body. |  |
IMPORTANT
To achieve optimal results, replace all sprinklers on a zone with MP Rotators and adjust the run time accordingly. The precipitation rate of the MP Rotator is much lower than sprays and operating times will be similar to stream rotor zones.
A consistent operating pressure greater than > 55 PSI (3.7 BAR) shortens the life of the sprinkler, increases rotation speed, reduces sprinkler uniformity and voids the trade warranty.
Resources
Still not finding the answers?
Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage, simply click on the contact button below to submit an email request.
