Hunter Technical Support Document
How do I install the I-40 Turf Cup Kit?
| STEP ONE | STEP TWO |
|---|---|
I-40 Rotor and Turf Cup Kit |
Access the top cover screws by prying out the little covers one at a time. Be careful not to lose them. |
| STEP THREE | STEP FOUR |
Remove plastic screw covers |
After the screws are exposed you can use a common phillips head screwdriver to remove. |
| STEP FIVE | STEP SIX |
Remove both screws. |
Once the screws are removed you can now take off the stock body cap. |
| STEP SEVEN | STEP EIGHT |
If done properly the riser seal and riser seat should still be in place. |
You can now push on the turf cup body cap, while it's compressed tighten the screws. |
| STEP NINE | STEP TEN |
Hold cap whille tightening screws. |
Tighten both screws |
| STEP ELEVEN | |
With both screws tight it's now safe to install your sod into the turf cup. |
Resources
Still not finding the answers?
Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage, simply click on the contact button below to submit an email request.
