Hunter Technical Support Document

I-20 Rotary Sprinkler Installation Detail

Product Lines:
Topics: 
Installation Procedures

I-20 Saddle

 

I-20 6" with Swing Joint

 

 

 

I-20 12 with Hunter Swing Joint

 

I-20 12 with Swing Joint

 

 

Replacing the Riser Seal on a Hunter rotor

I-20 with Poly PipeSTEP TWO

Place the base of the riser on a solid surface and grip the spring and riser body firmly. With the other hand, snap off the body cap—with your palm on top of the logo cap, pull up with your fingers.

STEP THREESTEP FOUR

While still gripping the spring and body, remove the rubber seal.

When you remove the seal, the spring's tension will be released. Remove the plastic spring and plastic springseat (if it was not pushed off by the spring).

STEP FIVE

Now that the old seal is removed, the new seals and plastic spring seat can slide over the top of the rotor's turret and onto the riser. Be sure to install the spring seat prior to the riser seal. After the new components are installed you can then reinstall the rotors body cap.

 

Resources

Rate this Article: 
Average: 1 (1 vote)

Still not finding the answers?

View more support documents

Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage. Simply click on the contact button below to submit an email request.

Related Links