Hunter Technical Support Document

Share

Solar Sync ACC Controller

Topics: 
Installation Procedures

The ACC Controller is programmed with Solar Sync technology and, therefore, does not require the use of the Solar Sync module. Simply mount the Wireless Receiver on the controller cabinet using an available knock out and secure with the supplied conduit nut. Or, use the supplied brackets to mount the Wireless Receiver on the wall, similar to the Pro-C installation shown on page 8. Depending on the installation, the supplied 1.5" (3.8 cm) extender may be required. Route the wires from the Wireless Receiver in to the controller cabinet.

  1. Make sure power to the controller is turned off

  2. Connect the black Receiver wire to the black “ET” terminal on the master module

  3. Connect the green Receiver wire to the green “ET” terminal on the master module

ACC Controller

 

Note: *The X-Core and ACC controllers have the Solar Sync software built in. Please see the controllers’ owner’s manuals for Solar Sync programming instructions.

 

Rate this Article: 
No votes yet

Related Links