Sprays - Adjusting the Radius on Spray Nozzles

Share

Tabs

Read Article

    The radius, or distance the water sprays on Hunter Nozzles can be adjusted by turning the center screw on top of the nozzle. This will increase or decrease the radius. All nozzles come from the factory in the fully open position (fully counterclockwise position).

FAQs

Step 1

Ensure that the nozzle is fully screwed down onto the pop up or shrub body assembly.

Step 2

To decrease the radius, hold the top of the nozzle edge using your hand.  Next, turn the screw in the clockwise direction using a small flathead screwdriver.  If you need to reduce the radius more than 25%, install a smaller radius nozzle for this location.

Rate this Article: 
Average: 4 (3 votes)