Sports Fields

Share

Electric Valve-In-Head TTS rotors are equipped with a selector to control operation of the rotor. The selector is located on the flange compartment’s lid. From the factory, the selector is set to the AUTO position which is located midway between the ON and OFF positions (fig 1).

Several tools are available to make ON-AUTO-OFF selections:

 

• T-Handle Tool – PN 053191

• Hunter Wrench – PN 461720

• Snap-ring Tool – PN 052510

Prior to removal of the upper snap-ring assembly, the rubberized logo cap must be removed and the riser assembly must be pressed below the snap-ring’s rubberized seal. If the procedure below is not followed, the upper snap-ring assembly cannot be removed from the G900 Series rotors:

 

The first practice in troubleshooting “Revolving Messages” is press the CLEAR button 3 times to remove old invalid messages. When a message is generated, it will continue to be present even if the error has internally corrected. This is by design to inform the user that there is/was a controller incident.

Note: When the term “CLEAN” is stated below, power down the controller and use a soft toothbrush and alcohol to gently break away deposits.

(Image Needed: boards identified)

No display: Check power connections. It's possible the fuse on the power supply board (PSB) has blown, and the controller will not power up until it has been replaced. The fuse is an AGC, 3 amp, fast-blow only.

NPT or National Pipe Thread has become a US standard for tapered threads used on pipe and fittings. The taper rate for all NPT thread is 1.6 mm. When torque is applied to an NPT fitting compression will cause the flanks to create a seal; as opposed to the alternative parallel or straight thread fittings, which thread merely to hold pieces together not to provide a seal.

Edit Decoders: This option only appears in VSX/IDS Field Decoder Controllers. Decoder controllers are always configured for 103 stations, plus a Pump output. Each station has a corresponding decoder installed in the field, connected to a two-wire path.

The Edit Decoder function allows you to change the assignments of decoder identification numbers to station numbers in the field.

This can be used whenever a decoder is replaced, added, or exchanged with another decoder, after initial setup.

The first practice in troubleshooting “Revolving Messages” is press the CLEAR button 3 times to remove old invalid messages. When a message is generated, it will continue to be present even if the error has internally corrected. This is by design to inform the user that there is/was a controller incident.

Note: When the term “CLEAN” is stated below, power down the controller and use a soft toothbrush and alcohol to gently break away deposits.

Line Fault: This display indicates a power or wiring related problem. Generally it will appear if an IDS or VSX controller has detected an Overload condition (transformer current draw in excess of 2 amps), and no stations were scheduled to be running. If there were no stations running but a 2 + amp current was sensed, this would indicate a direct short circuit in the two wire path, or a potential transformer problem.

To test one of the main component behind the two wire path's power supply (Decoder Output Board), follow these steps:

Edit Decoders: This option only appears in VSX/IDS Field Decoder Controllers. Decoder controllers are always configured for 103 stations, plus a Pump output. Each station has a corresponding decoder installed in the field, connected to a two-wire path.

The Edit Decoder function allows you to change the assignments of decoder identification numbers to station numbers in the field.

This can be used whenever a decoder is replaced, added, or exchanged with another decoder, after initial setup.

No display: Check power connections. It's possible the fuse on the power supply board (PSB) has blown, and the controller will not power up until it has been replaced. The fuse is an AGC, 3 amp, fast-blow only.

Pages