X-Core - Programmable Sensor Override

The X-Core allows the user to program the controller so that the sensor disables watering on only desired stations. For example, patio gardens that have pots under overhangs and roofs may not receive water when it rains and will continue to need to be watered during periods of rain. To program sensor override:

NOTE: The controller default is for the sensor to disable watering on all zones when rain occurs.

1

Turn the dial to the RUN position.
 

2

Press and hold the minus (-) button down while turning the dial to START TIMES position.

3

Release the minus (-) button. At this point, the display will show the station number, ON, and the icon, will be flashing.
 

4

Press the plus (+) or minus (-) button to enable or disable the sensor for the station shown. ON = Sensor enabled (will suspend irrigation). OFF = Sensor disabled (will allow watering).


 

5

Use the left arrow (<) or right arrow (>) buttons to scroll to the next station that you would like to program the sensor override. Turn the dail to Run after programming sensor override.
 

أما زلت بحاجة إلى مساعدة؟ نحن هنا.

أخبرنا بما تحتاج إلى دعم بشأنه، وسنجد لك أفضل حل.

الاتصال بالدعم