Support
NODE-BT Support

Node-BT - Connecting Weather Sensor

A Hunter Mini-Clik®, Freeze-Clik®, or Wired Rain-Clik® sensor can be connected to NODE-BT. The purpose of this sensor is to stop watering when weather conditions occur.  Irritation will resume the automatic schedule when the switch closes again following these events.  For CLIK sensor options for the NODE-BT controller, please visit the product section here.   

Wiring Sensor
  1. Cut the yellow wire loop attached to the NODE-BT at approximately the middle of the loop.
  2. Remove approximately 1/2" (1.3 cm) of insulation from each wire. Attach one yellow wire to each of the wires of the weather sensor. You can mount the sensor up to 100' (30 m) from NODE-BT using 18 AWG (1 mm2 ) minimum wire size. Secure all wire connections with waterproof connectors.

Sensor App Setup
  1. Enable the weather sensor.  MORE > CONTROLLER SETTINGS > RAIN SENSOR.
  2. Select SLIDE BAR.
Rate this Article: 
0

Was this article helpful? Ja | No

S U P P O R T
M E N U