Designers - Page 2

A Hunter MINI-CLIK®, FREEZE-CLIK®, or RAIN-CLIK™ sensor can be connected to your X2 controller.

USA

The program(s) should already be configured after you finish the setup wizard, but you may want to adjust your run times, start times, or water days later.

The X2 Standard Mode programming allows you to create traditional irrigation programs using Programs A, B, and C — just like Hunter X-Core® or Pro-C® controllers. This mode offers less flexibility than Hydrawise Advanced Mode. Key features include:

USA

You can run an irrigation zone on demand from from your web browser or from your Hydrawise app.  For manual operation, read this article.

Please view the steps and screenshots to access this feature:

USA

Register for an account online

If you have not done so already, we recommend creating an account using the Centralus login page.

The A2C controller uses two different types on communication devices, a WiFi module or a Local Area Network (LAN) connection. For more information on the connecting the A2C controller to the Centralus software, please follow the steps in the articles listed below.

USA

Here is a list of the error codes and ways to troubleshoot them:

Metric

The CLIK DELAY option is designed to set number of days for watering to remain off, after sensor has been activated and restored.

Metric

The X2 Controller is compatible with Hunter Remote Controls (not included). The SmartPort® wiring harness (included with all Hunter Remotes) allows for fast and easy use of the Hunter controls. The Hunter remotes make it possible for you to operate the system without having to walk back and forth to the controller.

To install the SmartPort connector

Metric

A Hunter CLIK sensor or closed circuit type weather sensors can be connected to the X2. The purpose of this sensor is to stop automatic watering when weather conditions dictate.

Metric

NOTE: Complete this section only if you have a pump start relay installed. A pump start relay is a device that uses a signal from the controller to actuate a separate electrical circuit to energize a pump to provide water to your system.

The controller should be mounted at least a 15 ft (4.5 m) away from both the pump start relay and pump to minimize any potential electrical interference.

Metric

NOTE: Complete this section only if you have a master valve installed in your irrigation system. A master valve is a “normally closed” valve installed at the supply point of the main line that opens only when the controller initiates a watering program.  Whenever one of the irrigation zone valves is told to open by the controller, the controller also signals the master valve to open. The purpose of the master valve is to shut off the water to the irrigation system when none of the zone valves are operating. 

Metric

Pages