The DUAL48M decoder output module is designed for use in all Hunter I-CORE series controllers and provides two-wire decoder outputs for the Hunter DUAL family of field decoders.
Note: This module is not compatible with any other controller.
The decoder output module installs in the first three expansion slots of the controller. The station size of this module is 48 maximum.
Turn the dial to the Run position.
Open the facepack door, and locate the module slide lock. Slide the module lock to the unlocked “Power Off” position.
Remove any previously installed ICM-600 station output modules. Install the DUAL48M in the first 3 slots to the right of the Power Module. Do not attempt to force the module into any other position.
Install the module by aligning it in the first three expansion slots, and slide it in, pushing until the module is seated flush with the Power Module to the left.
Slide the module lock to the locked “Power On” position. The I-CORE will apply power to the module and recognize it for decoder use (controller maximum station size is now 48 stations).
Note: NOTE: The DUAL48M will display a line open message if the module is installed and no two-wire paths and decoders are wired to the controller.
Installation for Combined Decoder and ICM-600 Module
The I-CORE will accept both the DUAL48M decoder module and standard ICM-600 expansion modules (up to 2 additional ICMs in the plastic cabinet and up to 4 in the metal and plastic pedestal controllers), providing the ability to attach decoders and conventionally wired stations to the controller. The ICM-600 module(s) must be installed to the left of the DUAL Decoder Module with no gaps. The 48 station maximum does not change. The decoder module will automatically recognize the number of conventional stations (six per ICM-600). The "Available Station" display will change to show the range of available decoder stations (for example, 7-48, 13-48, etc).
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.