Support
Large Rotors Support

How do I install the I-40 Turf Cup Kit?

STEP ONE STEP TWO

I-40 Rotor and Turf Cup Kit

Access the top cover screws by prying out the little covers one at a time. Be careful not to lose them.

  
STEP THREE STEP FOUR

Remove plastic screw covers

After the screws are exposed you can use a common phillips head screwdriver to remove.

STEP FIVE STEP SIX

Remove both screws.

  

Once the screws are removed you can now take off the stock body cap.

STEP SEVEN STEP EIGHT

If done properly the riser seal and riser seat should still be in place.

You can now push on the turf cup body cap, while it's compressed tighten the screws.

STEP NINE STEP TEN

Hold cap whille tightening screws.

Tighten both screws

STEP ELEVEN

With both screws tight it's now safe to install your sod into the turf cup.

 

Resources

I-40 Brochure
Rate this Article: 
4.5

Was this article helpful? Yes | No