Support
ACC2 Support

ACC2 - Start Stations, Programs, and Blocks

Tabs

Read Article

When using Conditional Response to start a station, Block, or program, other options appear below the selection.

 

Mode

If the Mode is set to Manual, the station, Block, or program will run alone, and all other automatic irrigation is stopped until the response is finished.

If the Mode is set to Auto, the response will occur without halting other scheduled irrigation. If the system is using Flow Manager, the response may not begin immediately. The responding stations will be factored into the Flow Target, as available, by the Flow Manager.

If Stop if Condition Clears is checked, the station, Block, or program will only run while the trigger condition is present. If the condition continues, a station or Block will run for the specified run time, and a program will run once for the duration of the program.

If the box is not checked, the response will continue for the total run time or duration of the program.

Rate this Article: 

Was this article helpful? Yes | No