ACC2 - Controller Installation

1. Lift and remove the controller front door.
2. Disconnect face pack cable.
3. Press down on the release lever.
4. Tilt-out face frame and remove.

Metal pedestal mounting instructions are included with the pedestal hardware.

1. The bottom of the wall bracket should be eye-level for the center of the controller display.
2. The paper template is supplied for marking all anchor holes.
3. Level, mark, and use a ⅛" drill bit for anchor holes. Do not forget the lower center hole in the controller cabinet.
4. Secure wall bracket with supplied or equal hardware.
5. Hang controller on a wall bracket with rear hooks.
6. Secure lower center screw from inside the cabinet to complete mounting

ACC2 may operate with either 120VAC or 230VAC power input. Connections should be made by a licensed electrician. Follow all applicable electrical codes.

1. Remove the wiring compartment cover.
2. Verify that AC power is off at the main circuit breaker.
3. Route incoming AC power wires (minimum 14 AWG/2 mm2 ) through the approved conduit into the wiring compartment. Strip wire ends approximately 1/2”/ 12 mm.
4. Make AC wiring connections using supplied terminal block or wire nuts and electrical tape, in accordance with local codes. 5. Always cap off or insulate the unused hot wire from the transformer.

Note: The plastic model requires a step-down drill bit for template holes.