Support
EZDT - Handheld Wireless Diagnostic Tool

EZDT - Firmware Udpates

If new firmware versions are released for any of these components, the files can be downloaded from the Hunter website and uploaded to the EZ-DT via microSD card within the battery compartment (microSD card not included). To update the firmware of an ICC2 facepack or an EZ-DM decoder output module, use the ribbon cable connector located under the top cover.

 

NOTE: EZ-1 decoders can be updated via red and blue wired connection.

 

ICC2 FACEPACK

  1. From the HOME Screen, select UPDATE.
  2. Select the ICC2 model.
  3. Remove the ribbon cable from the ICC2 POWER MODULE.
  4. Insert the ribbon into the EZ-DT (shown in display). Select ENTER.
  5. Successful updating of the facepack is confirmed with TWO BEEPS and a GREEN checkmark.

IMPORTANT: Make sure the 9V battery is removed from the facepack prior to this update.

    

EZ-DM (DECODER MODULE)

  1. From the HOME Screen, select UPDATE
  2. Select the EZ-DM model.
  3. Remove the ribbon cable from the ICC2 FACEPACK.
  4. Insert ribbon into the EZ-DT (as shown in display). Select ENTER.
  5. Successful updating of the EZ-DM (decoder module) is confirmed with TWO BEEPS and a GREEN checkmark.

   

EZ-1 (DECODER)

  1. From the HOME Screen, select UPDATE.
  2. Select the EZ-1 model.
  3. Insert red and blue wires from the decoder into the EZ-DT Programming Ports. Select ENTERNOTE: You can update multiple decoders at once via the two-wire path.
  4. Successful updating of the decoder is confirmed with TWO BEEPS and a GREEN checkmark.

   

Rate this Article: 
0

¿Te resultó útil este artículo? | No