Distribuidores - Page 70

Steps to replace the front panel on a I-Core controller:

STEP ONESTEP TWO

Turn controller power off!

USA

The easiest way to make adjustments on your Hunter rotor is to use a Hunter adjustment wrench. This tool can be purchased from your local distributor.

USA

With MP Rotators, 80% of the filter can be plugged without a performance drop. MP Rotator filters can be removed for cleaning and/or replacement. Please view the chart below for more details on each of the filter sizes.

USA

There is a blank nozzle available as part of the Low Angle Nozzle Set (PGP-ADJ P/N: 233200 & PGP Ultra/I-20 P/N:356605SP), which can be inserted into the rotor to shut off the flow of water.

USA
The PS comes from the factory with a preset spray arc of 1º (a very thin stream). The raised dot on top of the nozzle indicates the adjustable (left) edge of the spray pattern.

USA

 

The Hunter Adjustable Arc nozzles come from the factory with a preset arc of 25 degrees.

USA

If the Solar Sync Seasonal Adjustment is too high or too low you may need to change the Water Adjustment feature on your controller or Solar Sync Module on older models. This will allow you to fine-tune your station Run Times to allow for more watering or less watering.

USA

                        

There are some cases where you will need to readdress the sensor on the roof to the receiver mounted near the controller so they are on the same frequency. They are a matched set out of the box however after a power outage the receiver can lose its address.

On a new install Its always a good idea to check communication at the controller before installing the sensor in it's permanent location.

USA

Wire lengths for sensors: 

  • Mini Clik can be ran up to 200’ (60m)
  • Rain Clik can be ran up to 200’
  • Solar Sync can be ran up to 200’

USA

Pages