Certyfikowani specjaliści od nawadniania - Page 32

A BLOCK is an electronic group of stations that runs at the same time, for the same run time, within a program (Blocks replace “SSGs” in original ACC).

USA

The primary use for this setting is to allow stations to be named. Most other functions are described in more detail in the Flow Operations section.

USA

The ACC2 controller allows up to six Pump and/or Master Valve outputs to be assigned in the controller. This applies to the decoder and conventional models. In this article, the following topics are covered:

USA

A new controller installation will begin with at least one or two ATTENTION messages, because the controller has experienced a "power outage" in shipping, and might be discovering new modules. This is normal. Messages on the screen do not interfere with normal irrigation.

When power is first turned on (either with the power switch, or closing one of the slide locks), the Hunter logo screen appears, and the controller begins searching for any irrigation events it may have missed during a power outage.

USA

About this event

RSVP Required

Limited to the first 25 people who respond.

What will be covered

  • Update on Drought Conditions
  • Status of Device Incentive Programs
  • Updates to CA MWELO
  • Auditor Review and Check List
  • Irrigation Scheduling for CA Natives
  • How Drip Tubing is made
  • Hunter's water efficient products

The "NO AC" display is a diagnostic message telling you that the controller has stopped receiving AC power. The controller is running on the power supplied by the backup battery.

USA

The PSR-B was developed to provide a solution for irrigation controller and pump start relays installations that have insufficient power to energize the pump relay. A common cause for this problem is the use of too small a wire size for the distance from controller to the pump start relay.

USA

 

You can manually test proper operation of the rain sensor by using the One Touch Manual Start. During the Manual All stations cycle, press the test button on the “Clik-type” sensor (eg. Mini-Clik®) to interrupt watering.

Note: The rain sensor will only interrupt watering in Manual All Stations and automatic programming.  Manual single station will override the sensor circuit.

USA

Pages