Support
WR-Clik / Rain-Clik Support

Wireless Rain-Clik - Setting the Transmitter Address at the Receiver

Each wireless transmitter is produced with a unique address. A receiver must learn this address to work with that transmitter. This step is only necessary if transmitters and receivers are purchased separately.

Note: Units purchased as a kit will already have their communication address preset. No addressing is necessary, however, if the receiver or transmitter is replaced, you need to reset the address.

Step 1

Remove AC POWER to the controller.  Press and hold the bypass button on the receiver.

Step 2

While the bypass button is depressed, restore power to the controller. The sensor status indicator light should light up AMBER indicating that the receiver is ready to learn a new address.

Step 3

Press and hold the QUICK RESPONSE BUTTON on the transmitter for at least 5 seconds.

Step 4

Within 4 seconds, the receiver’s sensor status indicator light should turn RED. The receiver has now learned the address and it will be retained even in the event of a power outage.

Step 5

Release the button on the transmitter. The sensor status indicator light should turn GREEN.

Rate this Article: 
2

Was this article helpful? Да | No