Pump Start Relay - Connect to Controller





Remove Pump Start Relay cover plate by removing the four screws with phillips screwdriver.


Run a single wire from the "common" terminal on the controller to one of the yellow wires on the pump Start Relay.


Run a single wire from the "MV/Pump"  terminal on the controller to the other yellow wire on the pump Start Relay.


Use the enclosed wire nuts to make the connections and verfiy that they are secure.


Install Pump Start Relay cover plate and four screws.  Close and lock the cabinet door.

The yellow wires in the lower wiring compartment of the Pump Start Relay are to be attached to your irrigation controller.

  1. Common
  2. MV Pump


По-прежнему нужна помощь? Мы к вашим услугам!

Изложите свой вопрос, и мы постараемся найти для вас оптимальное решение.

Запрос в службу поддержки