Support
Pro-C Support

Pro-C - Clearing Controller’s Memory/Resetting Controller

Pro-C®

Pro-C Advanced: 08, Resetting Memory

Back
Search all videos
More Hunter Videos ▼
Right-click on the video format below and select Save As...MOV | WMVDownload

Category:

  • Field Knowledge

Product Lines:

  • Controllers
Products: 
Pro-C®

Length:

  • Quick Tip
Published: 
July 6, 2017

If want to clear the memory on your controller and start from fresh or if your controller is not responding to your commands, you can reset the Pro-C.

 

  • Installation Procedures
Pro-C with Solar Sync dial position
  1. Press and hold the  program button.
  2. Press and release and the RESET button on the back of the front panel.
  3. Wait until the display shows 12:00 am.
  4. Release the  button.

The controller is now ready to be reprogrammed.

Pro-C (2009 - 2014) with Seasonal Adjust Dial Position
  1. Turn the dial to the RUN
  2. Position Press and hold the  button.
  3. Press and release the RESET button on the back of the front panel.
  4. Wait until the display shows 12:00a.m.
  5. Release the  button.
  6. The display will show 12:00a.m.

The controller is now ready to be reprogrammed.

Pro-C (2009 or older) with Manual All Station dial position
  1. Turn the dial to the RUN position.
  2. Remove the 9V battery.
  3. Press and hold the  ,  and  program buttons simultaneously.
  4. Press and release the Reset button on the back of the front panel.
  5. Release all three buttons when you see 12:00a.m. on the display.

The controller is now ready to be reprogrammed.

Note: Any programs that have been saved with Easy Retrieve will remain after resetting controller.

Rate this Article: 
0

Was this article helpful? Yes | No

Support Menu

S U P P O R T
M E N U