Support
Pro-C Support

Pro-C - Programmable Sensor Override

Pro-C®

Pro-C Advanced: 01, Programmable Sensor Override

Back
Search all videos
More Hunter Videos ▼
Right-click on the video format below and select Save As...MOV | WMVDownload

Category:

  • Field Knowledge

Product Lines:

  • Controllers
Products: 
Pro-C®

Length:

  • Quick Tip
Published: 
July 6, 2017

The Pro-C allows the user to program the controller so that the sensor disables watering on only desired stations. For example, patio gardens that have pots under overhangs and roofs may not receive water when it rains and will continue to need to be watered during periods of rain.

  • Installation Procedures

To program sensor override:

  1. Turn the dial to the RUN position.
  2. Press and hold the   button while turning the dial to the START TIMES position.
  3. Release the   button. The display will show the station number, the SENSOR icon, and ON will be flashing.
  4. Press the   or   button to enable or disable the sensor for the station shown.
    ON = Sensor enabled (will suspend irrigation)
    OFF = Sensor disabled (will allow watering)
  5. Use the   or   buttons to scroll to the next station that you would like to program the sensor override.

NOTE:
The controller default is for the sensor to disable watering on all zones when rain occurs.
A station that is running in the sensor override mode will display the word “SENSOR” and flash the icon.

Rate this Article: 
0

Was this article helpful? Yes | No

Support Menu

S U P P O R T
M E N U