Support
Pump Start Relay Support

Pump Start Relay - Connect to Controller

Tabs

Read Article

 

 

 

The yellow wires in the lower wiring compartment of the Pump Start Relay are to be attached to your irrigation controller.

  1. Common
  2. MV Pump

 

Step 1

Remove Pump Start Relay cover plate by removing the four screws with phillips screwdriver.

Step 2

Run a single wire from the "common" terminal on the controller to one of the yellow wires on the pump Start Relay.

Step 3

Run a single wire from the "MV/Pump"  terminal on the controller to the other yellow wire on the pump Start Relay.

Step 4

Use the enclosed wire nuts to make the connections and verfiy that they are secure.

Step 5

Install Pump Start Relay cover plate and four screws.  Close and lock the cabinet door.

Rate this Article: 
0

Was this article helpful? Yes | No