Support
Pump Start Relay Support

Pump Start Relay - Connect to Power Source

Topics: 

PSR Connect Power Source

NOTE: Connecting the Pump Start Relay should only be done by a licensed electrician following local codes. Improper installation could result in shock or fire hazard.

Step 1

To prevent electric shock, turn the main circuit breaker switch to “off” prior to making any electrical connections.

Step 2

Assemble conduit piping and connect AC power from the power source to one side (LINE IN) of the relay.

Step 3

Assemble conduit piping and connect wiring from the pump motor to the other side of the relay (LOAD OUT).

Step 4

Check to make sure there are no exposed or loose connections.

Rate this Article: 

Was this article helpful? Yes | No