Sports Fields - Page 7

In hydraulic installations, the flange compartment should be used to make the Control Tubing connections to the rotor. This allows for tubing connections, pressure tests and flushing of the control lines - all without digging.

USA

Electric Valve-In-Head TTS rotors are equipped with a selector to control operation of the rotor. The selector is located on the flange compartment’s lid. From the factory, the selector is set to the AUTO position which is located midway between the ON and OFF positions (fig 1).

Several tools are available to make ON-AUTO-OFF selections:

 

• T-Handle Tool – PN 053191

• Hunter Wrench – PN 461720

• Snap-ring Tool – PN 052510

USA
STEP ONE STEP TWO

1. From the home screen start by pressing the "Options" button.

USA
STEP ONESTEP TWO

The I-90 turf cup kit attaches to the top of the rotors riser assembly.

Metric
The MP Rotator has a lower precipitation rate than typical spray heads, so your run times need to be lengthened. Your run times with the MP Rotator may be two to three times longer than a standard spray zone.
Metric

Below is a chart indicating the maximum wire runs that can be used
when installing Hunter AC solenoids and valves.

Metric

Proper grounding of decoder systems is part of the installation that requires consideration. Properly grounded decoder systems perform very well even in high-lightning regions. Poor grounding often results in unnecessary equipment losses and irrigation down time.

Earth grounding rules for the I-Core decoder controllers are the same as for the conventional I-Core controllers. A large ground lug is provided for connection of bare copper wire to earth grounding hardware.

Metric

The stainless steel option on Hunter rotors offers mutliple benefits, here are a few:

Metric

Pages