P2C - Connecting a Hunter Clik Weather Sensor

A Hunter weather sensor or other micro-switch-type weather sensors can be connected to the Pro-C® Controller. The purpose of this sensor is to stop automatic watering when weather conditions dictate.

  1. Remove the metal jumper plate that is attached across SEN-2 and COM.
  2. Connect one wire from the sensor to the SEN-2 screw terminal and the other sensor wire to the COM terminal. When the weather sensor has deactivated automatic watering, OFF will appear on the display.

IMPORTANT: The SEN-1 terminal will only be used for the Solar Sync Sensor. Learn More

Pro-C Model Sensor Wiring Comparison Chart

 

IMPORTANT: The Manual single-station function ignores any attached sensor and will allow watering.

 

 

 

Pro-C ModelWiring Diagram

PC-400 (3rd Generation)

 

  1. Route the wires from the rain sensor up through the same conduit used for valve wiring.
  2. Remove the flat jumper from the two SEN terminals.
  3. Connect one wire to the SEN terminal and one to the other SEN terminal.

PC-300 (2nd Generation)

 

  1. Route the wires from the rain sensor up through the same conduit used for valve wiring.
  2. Remove the flat jumper from the two SEN terminals.
  3. Connect one wire to the SEN terminal and one to the other SEN terminal.

 

PC-300 (Original Version)

 

  1. Route the wires from the rain sensor up through the same conduit used for valve wiring.
  2. Remove the flat jumper from the two SEN terminals.
  3. Connect one wire to the SEN terminal and one to the other SEN terminal.

 

 

还需要帮助吗?我们随时为您提供服务。

告诉我们您需要什么支持,我们将为您找到最佳解决方案。

联系客服