Importeure - Seite 63

Odd or Even day watering schedules are available on all Hunter controllers.

USA

The Pro-C controller is truly modular in design. This means that most components of the controller can be removed and replaced if needed.

For the newer style Pro-C (blue panel and buttons) the part number for the front panel is 821501. The part number for the older style Pro-C controllers (green buttons) is 526200.

Find a Hunter Distributor closest to you using our interactive lookup -  Get Hunter

USA

All Hunter controllers will also allow you to program non-water days when utilizing Odd or Even mode.

Example:

If you mow the lawn on Saturday morning, you may not want the irrigation to come on that day. You can select even watering and Saturday as a non-water day. This way, the controller will water every even day but never on Saturday.

USA

The Hunter XCore controller comes with an Interval Watering feature. This feature is adjusted under the Water Days dial position on the controller.

Interval Watering is a feature that allows you to select the number of days to pass before the next watering day.

 

USA

Interval Watering is a feature that allows you to select the number of days to pass before the next watering day. For example, an interval of 3 will cycle the program once every three days and water on the third day. An interval of 1 is every day and an interval of 2 will water every other day. An interval can be set for any time period up to 31 days.

USA

Hunter's EC controller comes with an Interval Watering feature. This Interval feature is set under the Water Days dial position on the controller. Interval Watering is a feature that allows you to select the number of days to pass before the next watering day.

Setting Interval Watering

With this option you can select interval watering from 1 to 31 days.

USA

A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.

USA

All Hunter controllers come equipped with a reset procedure and/or reset button. The reset procedure allows the user to clear electrical glitches and help restore factory settings.

 

USA

To stop a station from running when the system cycles automatically, simply remove all station Run Times for station that you do not to operate. Make sure Programs A, B, C and on some controllers Program D, have a run time set to "0:00" for station that you do not to operate.

 

 

USA

 

Hunter controller's contain multiple sized transformers, therefore each controller has different activation capabilities. Here is a list of recommended applications when using multiple Hunter solenoids.

Note: The max stations you see below for each controller model are only if you have this number of HUNTER solenoids wired to a single screw terminal.  This cant be done through basic programming in the controller.

USA

Seiten