Municipios - Page 53

Interval Watering is a feature that allows you to select the number of days to pass before the next watering day. For example, an interval of 3 will cycle the program once every three days and water on the third day. An interval of 1 is every day and an interval of 2 will water every other day. An interval can be set for any time period up to 31 days.

USA

A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.

USA

All Hunter controllers come equipped with a reset procedure and/or reset button. The reset procedure allows the user to clear electrical glitches and help restore factory settings.

 

USA

To stop a station from running when the system cycles automatically, simply remove all station Run Times for station that you do not to operate. Make sure Programs A, B, C and on some controllers Program D, have a run time set to "0:00" for station that you do not to operate.

 

 

USA

 

Hunter controller's contain multiple sized transformers, therefore each controller has different activation capabilities. Here is a list of recommended applications when using multiple Hunter solenoids.

Note: The max stations you see below for each controller model are only if you have this number of HUNTER solenoids wired to a single screw terminal.  This cant be done through basic programming in the controller.

USA

There are two reasons why your sprinklers would continue running:

USA

The WVP controller uses a numbered seven-day calendar to schedule the days to water. The display will show the days of the week as numbers 1–7.

When programming the current time and day, you can select a number to represent the current day of the week. The number can be changed to represent the user's preference. Many people use Sunday as day 1 while others use Monday as day 1. The day number can be set to whatever works best for you.

USA

The SVC controller uses a numbered seven-day calendar to schedule the days to water. The display will show the days of the week as numbers 1–7.

When programming the current time and day, you can select a number to represent the current day of the week. The number can be changed to represent the user's preference. Many people think of Sunday as day 1 while others think of Monday as day 1. The day number can be set to whatever works best for you.

USA

Easy Retrieve Program Memory

Easy Retrieve allows the user to save a program in the controller's memory for later use. The saved program can be retrieved at any time to overwrite unwanted changes in the current program. The saved program can then be used as a custom default restoration point.

USA

Pages