You and your partner who is in the Landscape Architecture Industry

 

 

 

Metric

Use the dial to go to Settings, Networking. Verify the address of the controller by viewing Network Info screen.

  1. Press soft key for Wi-Fi Setup.
  2. Check the box for Direct Connect.
  3. Open mobile device settings for Wi-Fi and search for HunterACC-xxxx (where –xxxx is the unique four digit number shown at Network Info), and connect.

 

;
 

USA

The standard MP Rotators have a matched precipitation rate of approximately 0.4 in/hr. This means any standard MP Rotator at any arc or radius can be placed on the same zone. The MP800SR can be configured to work well in head-to-head coverage in either square or triangular layouts. When square spacing is used, the resulting precipitation rate will be approximately 0.8 in/hr. Since this precipitation rate differs from the standard line of MP Rotators, you should zone the MP800 Series separately to maintain matched precipitation within each zone.

USA

ACC2 can be updated whenever a new version of the operating system or any of the internal modules is released. These updates are available here at the bottom of this article in the resources section. It is always advisable to stay current with controller updates.

Note:  Do not turn off power to the controller or facepack once the update has started. Damage may result.​

USA

The base model of HCC is supplied with an ICM-800 station output module. The capacity of the controller is increased when new station modules are installed and recognized.

Standard ICM station modules are available in 4, 8, and 22 station sizes (ICM-400, ICM-800, ICM-2200). These may be added at any time after initial installation. 

Note: The ICM-2200 (22 Station module) should always  be installed in the last two module slots to make it compatible.

USA

About this event

An industry mixer and overall good time for colleagues and friends for an annual cornhole tournament. Grab a partner and enjoy food and drinks!

For any questions or event details, please contact:

Chris Roesink
Chris.Roesink@hunterindustries.com
(760) 703-2474

About this event

An industry mixer and overall good time for colleagues and friends for an annual cornhole tournament. Grab a partner and enjoy food and drinks!

For any questions or event details, please contact:

Chris Roesink
Chris.Roesink@hunterindustries.com
(760) 703-2474

  1. Yellow power wires to ICC2 AC1 and AC2.
  2. White wires to the sensor terminals. Remove jumper plate from Sensor Terminals.
  3. Gray wires to PROB.

USA

Pages