Entrepreneurs

If the top of the screw is below the top of the turret, the screw must be turned counter-clockwise until it is flush with the top before removing the nozzle.
Métrique

 

 

 

Métrique

Register for an account online

If you have not done so already, we recommend creating an account using the Centralus login page.

The A2C controller uses two different types on communication devices, a WiFi module or a Local Area Network (LAN) connection. For more information on the connecting the A2C controller to the Centralus software, please follow the steps in the articles listed below.

USA

Here is a list of the error codes and ways to troubleshoot them:

Métrique

The CLIK DELAY option is designed to set number of days for watering to remain off, after sensor has been activated and restored.

Métrique

The X2 Controller is compatible with Hunter Remote Controls (not included). The SmartPort® wiring harness (included with all Hunter Remotes) allows for fast and easy use of the Hunter controls. The Hunter remotes make it possible for you to operate the system without having to walk back and forth to the controller.

To install the SmartPort connector

Métrique

A Hunter CLIK sensor or closed circuit type weather sensors can be connected to the X2. The purpose of this sensor is to stop automatic watering when weather conditions dictate.

Métrique

NOTE: Complete this section only if you have a pump start relay installed. A pump start relay is a device that uses a signal from the controller to actuate a separate electrical circuit to energize a pump to provide water to your system.

The controller should be mounted at least a 15 ft (4.5 m) away from both the pump start relay and pump to minimize any potential electrical interference.

Métrique

Pages