Specjaliści ds. krajobrazu - Page 27

  1. Recommended Eco-Mat installation depth per plant type: Turf: 4-6 inches (10-15 centimeters), Perennials and groundcovers: 8 inches (20 centimeters), Shrubs: 12 inches (30 centimeters.
  2. Recommended to achieve 80-85 percent compaction rate of soil above and below mat.
  3. Recommended to scarify soil to a depth of 6 inches (15 centimeters) below mat installation.
  4. Slightly sandy soil (sandy loam) is ideal when using subsurface drip irrigation - follow recommendations provided by soils report.
USA

For Hunter drip irrigation systems we recommend regulation and filtration systems on all residential and commercial applications. For drip irrigation systems using BTT, we recommend using Hunter HFR-075-25 or HFR-075-40. These filters install directly on 3/4" hose thread and BTT installs on the end of the filter system for filtration and regulated PSI of 25 or 40.

Metric

For drip irrigation systems using BTT, we recommend using regulation and filtration systems on all residential and commercial applications. Filters shall install directly on BTT's 3/4" hose thread outlet and connect to drip tubing providing regulated PSI.

Find a Hunter Distributor closest to you using our interactive lookup.  Get Hunter

Use the chart below for ordering reference.

USA

The Accu-Sync compares the pressure on the top side of the diaphragm (main water supply pressure) to the downstream pressure.  Pressure is adjusted by the unit forcing the diaphragm downward until the desired pressure is achieved.  The Accu-Sync automatically adjusts to main water supply pressure changes.  To properly set the dynamic pressure (running pressure) on the lateral line with Accu-Sync installed, we recommend doing so using our MP Guage on the last head of the line.  You can purchase a Hunter MP Gauge Assembly (shown below at farthest head) to accurately check the pressure. 

USA

With the Pro-C controller in production for 17 years, we have continuously made upgrades to accommodate the innovative features.  Below you will find every panel we manufactured for the Pro-C model including the NEW wifi replacement front panel.

USA

Selecting Specific Days of the Week to Water

USA

We would prefer that you use a Hunter valve with a Hunter DC latching solenoid, but we realize that sometimes you may be retrofitting existing systems that have another manufacturer’s valves. We have done testing on the following solenoids and have found these to operate with the Hunter SVC, WVC, NODE and XC Hybrid battery powered controllers. (some of these DC latching solenoids required a reduced system pressure, below 150 PSI (10.34 bars/1034.25 kPa), to ensure proper operation):

USA

Before securing the controller to the wall, you must first remove the lower wiring compartment door. The door can easily be removed by following the simple steps below:

  1. Open the external door using the included key if outdoor version model. Indoor version will have no external door.
  2. The lower wiring compartment door can now be removed by pushing downward. See illustration below:

 

 

 

USA

We recommend that a qualified licensed contractor perform this type of winterization method. The blowout method utilizes an air compressor with a cubic foot per minute (CFM) rating of 80-100 for any mainline of 2" or less. The compressor is attached to the mainline via a quick coupler, hose bib, or other type connection, which is located beyond the backflow device. Compressed air should not be blown through any backflow or flow meter device. For additional winterization procedures, we highly recommend contacting the local dealer for the most common local practices.

USA

Pages