Wireless Rain-Clik - Setting the Transmitter Address at the Receiver

Each wireless transmitter is produced with a unique address. A receiver must learn this address to work with that transmitter. This step is only necessary if transmitters and receivers are purchased separately.

Note: Units purchased as a kit will already have their communication address preset. No addressing is necessary, however, if the receiver or transmitter is replaced, you need to reset the address.

1

Remove AC POWER to the controller.  Press and hold the bypass button on the receiver.

2

While the bypass button is depressed, restore power to the controller. The sensor status indicator light should light up AMBER indicating that the receiver is ready to learn a new address.

3

Press and hold the QUICK RESPONSE BUTTON on the transmitter for at least 5 seconds.

4

Within 4 seconds, the receiver’s sensor status indicator light should turn RED. The receiver has now learned the address and it will be retained even in the event of a power outage.

5

Release the button on the transmitter. The sensor status indicator light should turn GREEN.

 

IMPORTANT: When the power is restored to the receiver the “SENSOR STATUS” LED will always appear red. The transmitter will automatically synchronize with the receiver (this may take from 1 minute to 1 hour).  If you want an immediate synchronization, press and hold down the “Test” button for 5 seconds, then release the “Test” button.  The “Sensor Status” LED will turn to green

Ainda precisa de ajuda? Conte conosco.

Conte-nos que tipo de ajuda você precisa para encontrarmos a melhor solução para você.

Fale com o suporte